adamrobots

http://www.raspberrypi.org/forums/viewtopic.php?f=78&t=53022

Shutdown button using gpio pin
thanks mholgatem I thought that to be the case i just wanted to make sure before i put the order in because all of the reviews i have seen show the small micro switches being used. Geting close to completing it now thanks again for your assistance.…

Comment by adamrobots March 2014 permalink
My pimame personalized video boot!
yes a start up video can have audio

Comment by adamrobots March 2014 permalink
Shutdown button using gpio pin
thanks im having a read now. appologies if this sounds stupid but can i use this type of switch http://www.ebay.co.uk/itm/12v-Push-Button-Switch-Momentary-ON-OFF-SPST-Car-Ignition-Engine-Start-Horn-/250955228751?pt=UK_CarsParts_Vehicles_CarParts_SM…

Comment by adamrobots March 2014 permalink
Shutdown button using gpio pin
iv read that if you set pin to be internally pulled up you need no resistors... is this something you physically have to do to the pins or is just written in the script/software?

Comment by adamrobots March 2014 permalink
Shutdown button using gpio pin
im looking a momentary push buttons and there seem to be many variations with different volts/amps etc. do i need a certain one or will any do the trick? and im right in saying that no resistors are required?

Comment by adamrobots March 2014 permalink
arcade cabinet speakers
i have a set of pc speakers at home i will check to see if there suitable when i get home thanks

Comment by adamrobots March 2014 permalink
arcade cabinet speakers
thanks for the replys. just need some that will fit in the 4/5'' holes iv drilled. i suppose they dont need to fill it completely and some speaker covers can help with appearence...?!

Comment by adamrobots March 2014 permalink
Shutdown button using gpio pin
I see i thought python was installed as standard. I cant see any reference to it being included in any updates so I have downloaded it.

Comment by adamrobots March 2014 permalink
Shutdown button using gpio pin
To install python for shutdown switch: sudo apt-get install python-dev wget http://pypi.python.org/packages/source/R/RPi.GPIO/RPi.GPIO-0.4.1a.tar.gz untar and install with "sudo python setup.py install" Is there a way off doing this fir…

Comment by adamrobots March 2014 permalink
rpi case
Decided on this http://www.ebay.co.uk/itm/Desktop-Mount-Red-for-Raspberry-Pi-Rev-2-Mount-Case-with-Support-Bar-/271060997639?pt=UK_Computing_Other_Computing_Networking&hash=item3f1c7e9607#ht_635wt_752

Comment by adamrobots February 2014 permalink
Arcade cabinet cooling
I think I will do without then. I will get some picks up soon. Thanks for the reply

Comment by adamrobots February 2014 permalink
autorun roms
* Link to previous post http://pimame.org/forum/discussion/714/auto-run-mame4all#Item_3

Comment by adamrobots February 2014 permalink
How to install a custom boot splash intro? (pimameintro.mov)
Thanks for the support it's greatly appreciated

Comment by adamrobots January 2014 permalink
How to install a custom boot splash intro? (pimameintro.mov)
This may seem like a stupid question but how do you actually replace the video? Can I do it on a card reader on my macbook or should I do it when it's booted up? Thanks for the help

Comment by adamrobots January 2014 permalink
PiMAME Bootsplash Video (Preview)
is there a maximum size for the video length and file size. i have created a video but its about 30 seconds long

Comment by adamrobots January 2014 permalink
PiMAME Bootsplash Video (Preview)
Hi Shea. I have been reading your blog and stumbled upon the section on the startup movie. Is the startup script already in the latest pimame? i dont need to add the script do i just replace the movie file..? think im going to purchase your book lat…

Comment by adamrobots January 2014 permalink
PiMAME Bootsplash Video (Preview)
Hi Im new here so i would first like to thank Shea for all his hard work. Im looking at building an arcade machine and i think pimame is the direction i will take. I am curious whether a new version has been released that has a boothsplash intro …

Comment by adamrobots January 2014 permalink

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

About

Username: adamrobots
Joined: January 2014
Visits: 181
Last Active: June 2014
Roles: Member

adamrobots

Howdy, Stranger!

About

Recommended Accessories